Registration Roller; Registration Clutch - Canon imageRUNNER 7095 Service Manual

Chapter 8
[1]
F-8-100

8.11.14 Registration Roller

8.11.14.1 Removing the Pre-Registration
Roller
1) Open the middle right cover, and remove the
screw [1]; detach the connector cover [2], and
remove the two screws [3]; then, detach the rear
fixing plate [4].
[3]
[4]
F-8-101
2) Remove the screw [5], and detach the front
fixing plate [6]; then, detach the preregistration
roller assembly [7].
[6]
[5]
F-8-102
8-42
[2]
[2]
[1]
[3]
[7]
3) Remove the two springs [8], E-ring [9], and
arm support shaft [10] at the front.
4) Remove the E-ring [11], spacer [12], and
bearing [13].
0010-9050
5) Perform steps 3) and 4) for the rear; then,
detach the pre-registration roller assembly.

8.11.15 Registration Clutch

8.11.15.1 Removing the Registration
Clutch
1) Remove the fixing/feed unit.
2) Shift up the releasing lever.
3) Disconnect the connector [1], and detach the
harness of the clutch from the clutch cover [2].
4) Remove the screw [3], and detach the clutch
cover [2] and the bearing [4].
[4]
[8]
[10]
[13]
[12]
[11]
[9]
F-8-103
[2]
[1]
[3]
F-8-104
0010-9136