Feeder; Feeder Items; Sorter; Sorter Items - Canon imageRUNNER 7095 Service Manual

Chapter 17

17.6.2 FEEDER

17.6.2.1 FEEDER Items

*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item Description
DOC-F- Use it to enable/disable stream reading mode.
SW *
settings
0: stream reading (default); 1: stream reading for small size only; 2: fixed reading
SIZE-SW Use it to enable/disable the mixed original detection mechanism (AB and inch).
settings
0: on (disable detection; default); 1: off (enable detection)
SLW- Use it to decrease the separation speed for original pickup.
SPRT *
settings
0: normal mode (default); 1: deceleration mode
LS-DBL Use it to enable/disable ADF high-speed duplexing mode.
**
settings
0: on (high-speed duplexing mode; default); 1: off (low-speed duplexing mode)
STAMP- Use it to indicate the installation of a stamp.
SW **
settings
0: stamp not installed; 1: stamp installed (default)
HS-DBL Use it to enable/disable ADF high-speed reversal mode.
*
settings
0: off (normal mode; default); 1: on (high-speed duplexing mode)
If an increase in productivity is desired in ADF duplexing mode, set it to '1'.

17.6.3 SORTER

17.6.3.1 SORTER Items

Sub item
BLNK- Use it to set the margin width for the left and right sides of the crease when the saddle stitcher is used.
SW
settings
0: normal width (5 mm); 1: large width (10 mm); 2: no margin (default)
MD- Use it to enable/disable bare-minimum (regression) mode.
SPRTN
settings
0: normal operation (default); 1: enable bare-minimum operation (no stapling, alignment)
SDL-PRS Use it to specify saddle stitcher press operation.
settings
0: enable pressing (one-way; default); 1: disable pressing; 2: enable pressing (both ways)
BUFF- Use it to enable/disable buffer operation of the finisher.
SW
settings
0: enable buffer operation (fault); 1: disable buffer operation
The use of paper with a low friction coefficient (e.g., coated paper) tends to cause displacement in
the buffer assembly. If such is the case, set it to '1' (a drop in productivity, however, will be a trade-
off).
TRY- Use it to switch over delivery operation for the stack tray of the finisher.
EJCT
settings
0: normal operation (default); 1: delivery for thin paper
The use of thin paper (i.e., paper with little body) can cause poor stacking. If such is the case, set it
to '1'.
17-86
T-17-65
FEEDER > OPTION
T-17-66
SORTER > OPTION
Description
0011-6102
Level
1
1
1
1
1
1
0011-6106
Level
1
1
1
1
1