Hdd - Canon imageRUNNER 7095 Service Manual

4.6.5 HDD

4.6.5.1 Points to Note on Handling the
Hard Disk
Keep the following in mind when attaching/re-
moving the hard disk.
1. Take countermeasures against electrostatic
before work to prevent the hard disk from being
damaged by electrostatic discharge.
2. Do not give a shock to the hard disk.
4.6.5.2 Making Preparations
1) Remove the main controller box cover [1].
- 10 screws [2]
[1]
[2]
F-4-33
4.6.5.3 Removing the Hard Disk
1) Remove the counter PCB [1].
- screw [2]
[2]
F-4-34
Be sure to remove the counter PCB before remov-
ing the hard disk, which otherwise could hit the
PCB and suffer damage.
[2]
[2]
[2]
[1]
2) Remove the hard disk [1].
- 2 screws [2]
0010-8740
4.6.5.4 Points to Note When Mounting the
0011-4562
Hard Disk
- When mounting the hard disk, fit the claw [1]
found on the back of the hard disk into the
opening [2] of the hard disk mounting plate;
then, push it in horizontally. If the connector of
the hard disk is at an angle in relation to the
socket (on the main control PCB), forcing it in
could well damage the connector.
0010-8741
4.6.5.5 After Replacing the Hard Disk
1) Formatting the HDD
Start up the machine in safe mode (i.e., turn on
the main power while holding down the 2 and 8
keys).
Using the HD formatting function of the SST,
execute full partition formatting. (For details,
see the chapter on upgrading.)
2) Downloading the System Software
Using the SST, download the following:
System, LANG,
dictionary, SSL encryption key, SSL CA
certificate, MEAP content.
3) Execute the following service mode item:
COPIER > FUNCTION > CLEAR > CA-KEY
(Level 2)
4) Turn off and then on the power.
[1]
F-4-35
[1]
[2]
F-4-36
RUI, PS-FONT,
Chapter 4
[2]
0010-8743
0010-8745
OCR
4-17