Turning Off The Host Machine; Installation Procedure - Canon imageRUNNER 7095 Service Manual

2.6.2 Turning Off the Host Machine

Turning Off the Main Power
When turning off the main power, be sure to go
through the following in strict sequence to protect
the machine's hard disk:
[1] Hold down on the power switch on the
control panel for 3 sec or more.
[2] Operate on the touch panel according to the
shut-down sequence indicated so that the main
power switch may be turned off.
[3] Turn off the main power switch.
[4] Disconnect the power cable (for the power
outlet).

2.6.3 Installation Procedure

1. Installation Procedure
Before starting to install the Voice Guidance Kit,
check to be sure that the Expansion Bus-D1 has
properly been installed.
2. Installation
1) Remove the main controller box cover [1].
- 10 screws [2]
[1]
[2]
F-2-142
0011-8636
0011-2711
[2]
[2]
[2]
2) Mount the facing plate [2] to the voice board
[1] by 2 binding screws (M3X6) [3].
[1]
F-2-143
3) The slide switch SW1 found on the voice
guidance board is set to 33 MHz at time of
shipment; be sure to set it to 66 MHz for use on
this machine.
66MHz
F-2-144
Chapter 2
[3]
[2]
2-37