Canon imageRUNNER 7095 Service Manual page 58

3) While holding down the front and rear of the
transfer/separation charging assembly [1], pull
it by 1 cm toward the front; then, detach it
toward the upper left.
Using alcohol, clean the transfer/ separation
charging wire.
F-2-24
4) While keeping the following in mind, mount
the transfer/separation charging assembly:
- The solvent must completely be dry.
- The gut wire must not be brought into contact
with the transfer guide [1] to avoid a cut.
- The grounding plate [2] must be on the outside
of the charging assembly frame [3] (See the
figure).
[1]
F-2-25
[2]
F-2-26
[1]
[3]
5) Connect the connector of the transfer/
separation charging assembly, and mount the
fixing.
6) Using a screw, mount the toner/separation
charging assembly front cover.
Push in the fixing/feeding assembly inside the
machine, and shift the fixing/feeding assembly
releasing lever [1] back into position.
F-2-27
7) Remove the screw [1], and detach the primary
charging assembly front cover [2].
F-2-28
8) Disconnect the connector [1], and release the
locking lever [3] of the primary charging
assembly [2]; then, take out the primary
charging assembly.
Using alcohol, clean the primary charging
assembly and the grid wire.
[1]
F-2-29
Do not start mounting work before the solvent has
become completely dry.
Chapter 2
[1]
[2]
[1]
[2]
[3]
2-11