Canon imageRUNNER 7095 Service Manual page 515

<CLEAR>
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
ERR Use it to reset an error code.
<Procedure>
1) Select the item, and press the OK key.
2) Turn off and then on the main power.
DC-CON Use it to initialize the RAM on the DC controller PCB.
The RAM will be initialized when the main power is turned off and then back on.
<Procedure>
1) Print out the particulars of service mode by making the following selections: COPIER >
FUNCTION > MISC-P > P-PRINT.
2) Select the item, and press the OK key.
3) Turn off and then back on the main power.
4) As necessary, enter the data printed out using P-PRINT.
R-CON Use it to initialize the RAM on the reader controller PCB.
<Procedure>
1) Print out the particulars of service mode by making the following selections:
COPIER>FUNCTION>MISC-P>P-PRINT.
2) Select the item, and press the OK key.
3) Turn off and then back on the main power.
4) As necessary, enter the data printed using P-PRINT.
JAM- Use it to reset the jam history.
HIST
The jam history will be reset when the OK key is pressed.
<Procedure>
1) Select the item, and press the OK key.
ERR- Use it to reset the error code history.
HIST
The error code history will be reset when the OK key is pressed.
<Procedure>
1) Select the item, and press the OK key.
PWD- Use it to reset the password for 'system administrator' set in user mode.
CLR
The password will be reset when the OK key is pressed.
<Procedure>
1) Select the item, and press the OK key.
ADRS- Use it to reset the address book data.
BK
The address book data will be reset when the main power is turned off and then back on.
<Procedure>
1) Select the item, and press the OK key.
2) Turn off and then back on the main power switch.
CNT- Use it to reset the service counter controlled by the main controller PCB.
MCON
The counter will be reset when the OK key is pressed.
<Procedure>
1) Select the item, and press the OK key.
CNT- Use it to reset the service counter controlled by the DC controller PCB.
DCON
The counter will be reset when the OK key is pressed.
<Procedure>
1) Select the item, and press the OK key.
OPTION Use it to initialize the RAM on the reader controller PCB. (items under COPIER>OPTION
** only)
The RAM will be initialized when the OK key is pressed.
<Procedure>
1) Select the item, and press the OK key.
T-17-41
COPIER > FUNCTION > CLEAR
Description
Chapter 17
Level
1
1
1
1
1
1
1
1
1
1
17-53