Canon imageRUNNER 7095 Service Manual page 531

*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
COUNTE Use it to set soft counter 1 for the user mode screen.
R1
settings
101: total 1 (fixed)
COUNTE Use it to set soft counters 2 through 6 for the user mode screen.
R2 to
settings
COUNTE
0 to 999
R6
For a list of settings, see the "Soft Counter Specifications" found later.
CONTRO enables/disables the charging mechanism (PDL job)
L
settings
0: do not restrict (default); 1: restrict
B4-L- For soft counters 1 through 6, use it to specify whether B4 should be counted as large-size or
CNT small-size.
settings
0: small size (default); 1: large size
COPY- Use it to prohibit reservation of a copy job when a card reader/coin robot is in use.
JOB
settings
0: enable reservation (default); 1: disable reservation
TAB- Use it to enable/disable rotation of images by 180 deg for PDL printing (if tab paper is used for
ROT landscape orientation).
settings
0: do not rotate; 1: rotate
PR- Use it to enable/disable display of the print pause function switch.
PSESW
settings
0: do not display (default); 1: display
IDPRN- Use it to switch between job types that initiate increases in group counters.
SW
settings
0:
for print category, Box Print, Report Print, End Local Print, PDL Print
for copy category, Copy
(default)
1:
for print category, Report Print, Send Local Print, PDL Print
for copy category, Copy, Box Print
CNT-SW Use it to switch between charge counter default indication items.
settings
0: 101 (total 1; default)
1: 102 (total 2), 202 (copy total 2), 127 (total A2)
2: 101 (total 1), 104 (total small), 103 (total large), 501 (scan total 1)
TAB- Use it to enable/disable auto cassette switchover in response to the absence of tab paper (index
ACC paper).
settings
0: do not switch between cassettes (default); 1: switch between cassettes
BCNT- Use it to switch between job types that initiate an increase in the box print count for the NE
AST controller.
settings
0: count as PDL job (default); 1: count as copy job
DOC- Use it to enable/disable the indication of the Remove Original message.
REM *
Normally, when an original is placed in the ADF and the Start button is pressed without
opening and then closing the copyboard cover after an original has been read from the
copyboard, the machine will indicate a message asking for the removal of the original. Use it
to enable/disable the indication of the message.
settings
0: do not indicate (default); 1: indicate
COPIER > OPTION > USER
Description
Chapter 17
Level
1
1
1
1
1
1
1
1
1
1
1
1
17-69