Canon imageRUNNER 7095 Service Manual page 75

Chapter 2
<Front Deck Left/Right>
1) Press the release button of the front deck (left/
right), and slide out the deck.
2) Loosen the 4 screws [1].
[1]
F-2-111
3) Move the cassette guide assembly (front) [1] to
the front or the rear to make adjustments.
- move the guide plate to the rear to decrease
the horizontal registration (left margin).
- move the guide plate to the front to increase
the horizontal registration (left margin).
F-2-112
4) Check to see that the horizontal registration (L;
left/right margin) of the images made on paper
from the front deck (left/right) is 2.5 +/-1.5
mm.
[1]
F-2-113
2-28
[1]
[1]
image
5) Tighten the 4 screws you loosened in step 2).
6) Put the front deck (left/right) back in place.
<Manual Feeder Tray>
1) Move the side guide plate [1] to the center, and
loosen the 2 manual feeder tray mounting
screws [2]; then, adjust the position of the
manual feeder tray.
[2]
F-2-114
<Duplexing Transport Unit>
1) Make the following selections in service mode:
COPIER > ADJUST > FEED-ADJ > ADJ-
REFER so that the image margin on the 2nd
side will be as indicated.
- if the margin is too large, decrease the setting
of ADJ-REFER (a change of 10 will decrease
the margin by 1 mm).
- if the margin is too small, increase the setting
of DJ-REFER (a change of 10 will increase the
margin by 1 mm).
W1=2.5 +/-2.0 mm
Wl
0 0
2 2
4 4
6 6
8 8
10 10
F-2-115
[1]