Jam Code (Dadf-M1) <Ir7086> - Canon imageRUNNER 7095 Service Manual

Chapter 16
Code Sensor type
0085 error
0090 ADF open
0091 user DF open
0092 cover open
0093 user cover open
0094 initial stationary
0095 cycle fault
0096 residual original
0097 manual feeder
residual original
0098 power-down
16.3.3 Jam Code (DADF-M1)
<iR7086>
Code Sensor
0001 post-separation sensor
0002 post-separation sensor
0003 registration sensor
0004 registration sensor
0005 read sensor
0006 read sensor
0007 delivery reversal sensor
0008 delivery reversal sensor
0042 post-separation sensor
0043 registration sensor
16-22
Sensor No. Description
PI1,PI2,PI A motor error other than an IPC communication or pickup error has
11 occurred. (less than 3 times)
PI10 The ADF is identified as being open.
PI10 The ADF is identified as being open while the machine is operating.
PI3,PI6 The cover is identified as being open.
PI3,PI6 The cover (front or rear) is identified as being open while the machine is
operating.
PI4,PI12,P At the start of operation, a sensor inside the paper path detects an original.
I13,S1,S2,
S3,S4,S5,S
9
S6 The pickup signal has been received for a specific period of time (2 sec)
in the absence of a detected original.
S1 The reversal sensor detects an original while the belt motor is moved for
a specific distance before the start of a left pickup job.
S1,S9 At time of manual feed pickup, the reversal sensor detects an original
while the manual feeder registration roller sensor also detects an original.
- A drop occurs in the voltage supplied by the host machine while the
machine is operating.
T-16-7
Notation Description
PI7 The post-separation sensor does not detect paper when paper
has been moved 452 mm after the start of separation.
PI7 - The separation sensor detects paper when paper has been
moved 500 mm (if extra-length, +200 mm) -45.5 mm after
registration pickup.
- the sensor goes on (paper with hole) before paper has been
fed 12 mm after the detection of the trailing edge; the
separation sensor detects paper after paper has been fed 50
mm from when the separation senor has gone on.
PI1 The registration sensor does not detect paper a feed length of
134.8 mm after the post-separation sensor has gone on.
PI1 The read sensor goes off before the registration sensor goes
off.
PI8 - The read sensor does not detect paper a feed length of 364.2
mm (182.1 x 2) from the point of registration.
- The read sensor does not detect paper a feed length of 157.4
mm (78.7 x 2) from the point of No. 2 registration.
PI8 - The read sensor detects paper a feed length of 500 mm (if
extra-length, +200 mm) after the start of feed, resumed after
a temporary stop for reading.
- At time of LTRR/LGL identification in mix mode, the read
sensor detects paper a feed length of 514 mm after the start of
feed from the edging wait point.
PI9 If not in high-speed duplexing mode, the delivery sensor does
not detect paper when paper is moved 132.1 mm after it has
reached the leading edge lower stream roller with reference to
the activation of the read sensor.
PI9 The delivery sensor detects paper a feed length of 161.9 mm
after the trailing edge read end point.
PI7 1st sheet, post-separation sensor, stationary
PI1 1st sheet, registration sensor, non arrival
0011-5509