Lower Fixing Roller - Canon imageRUNNER 7095 Service Manual

Chapter 9
8) While paying attention to the thermal switch
and the thermistor, remove the upper roller
assembly.
9) Remove the C-ring [1] at the front, and remove
the gear [2], bushing [3], and bearing [4].
F-9-24
10) Remove the C-ring [1] at the rear, and remove
the electrode plate [2], spacer [3], bearing [4],
and bushing [5].
[5]
F-9-25
9.5.2.2 Mounting the Fixing Upper Roller
Mount the upper roller by reversing the steps used
to remove it.
a. To prevent the surface of the roller from dirt or
damage, wrap paper after removing it.
b. Be sure that the longer cutoff A shown in the
figure is toward the rear.
F-9-26
9-14
[4]
[3]
[2]
[1]
[4]
[3]
[2]
[1]
A
c. When mounting, clean the electrode plate [1]
and the electrode terminal [2].
[2]

9.5.3 Lower Fixing Roller

9.5.3.1 Removing the Lower Fixing Roller
1) Remove the fixing assembly from the main
body.
2) Remove the fixing cleaning belt; then, clean
and detach the oil pan.
3) Open the upper fixing unit.
4) Remove the two screws [1], and detach the
lower separation claw support plate [2].
[1]
0010-9390
5) Remove the lower roller [3] from the fixing
assembly, and remove the E-rings [4] and the
bearings [5] from both front and rear.
[3]
[1]
F-9-27
[2] [1]
F-9-28
[4]
[5]
F-9-29
0010-9393