Canon imageRUNNER 7095 Service Manual page 504

Chapter 17
<BLANK>
Sub item
Be sure to enter the value indicated on the service label if you have replaced the DC controller PCB or
initialized the RAM.
BLANK-T Use it to enter the image lead edge non-image width adjustment value.
range: 0 to 2362
A higher setting will increase the non-image width.
BLANK-B Use it to enter the image trail edge non-image width adjustment value.
range: 0 to 2362
A higher setting will increase the non-image width.
Notes:
If you have changed BLANK-B and BLANK-TE, the higher setting will be given priority.
BLANK-TE Use it to enter a value of the non-image width in image main scanning direction (left, right).
range: 10 to 50
Notes:
If you have changed BLANK-B and BLANK-TE, the higher setting will be given priority.
<V-CONT>
Sub item
Enter the value indicated on the service label if you have replaced the DC controller PCB, initialized the
RAM, or replaced the potential sensor (EPOTOFST only).
EPOTOFST Use it to enter the offset value of the potential sensor.
range: 0 to 30
VL-OFST Use it to enter the offset value of the potential control light area target potential.
range: -50 to 50
VD-OFST Use it to enter the offset value of the potential control dark area target potential.
range: -50 to 50
DE-OFST Use it to enter the offset value for potential control VDC.
range: -50 to 50
OHP-OFST Use it to enter the offset value of transparency potential control.
range: -50 to 50
VD-OFS-O Use it to enter the offset value of the dark area target potential for transparency potential
control.
range: -50 to 50
<HV-PRI>
Sub item
GRID Use it to enter the adjustment value for the primary charging assembly grid current.
range: 400 to 900
Use it to enter the value indicated on the service label if you have replaced the DC controller
PCB or initialized the RAM.
17-42
T-17-22
COPIER > ADJUST > BLANK
Description
T-17-23
COPIER > ADJUST > V-CONT
Description
T-17-24
COPIER > ADJUST > HV-PRI
Description
Level
1
1
1
Level
1
1
1
1
1
1
Level
1