Canon imageRUNNER 7095 Service Manual page 525

*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
OVLP- Use it to enable/disable double-feeding detection mechanism.
MD
0: disable; 1: enable
ABC- Use it to switch over original background processing. (digital ABC setting switchover)
MODE *
A higher setting (between 1 and 3) will limit the background more.
settings
-1: limits removal of background density (for photo original or originals with complex
elements)
0: off (no idle rotation)
1: remove background 1
2: remove background 2
3: remove background 3
IDL- Use it to enable/disable the mechanism that computes the scan area based on the selected paper
MODE size.
settings
0: OFF (disable idle rotation)
1: use auto control by environment sensor
2: start idle rotation when fixing roller temperature is 100 deg C
3: start idle rotation when main power switch goes on
SCANSL Use it to enable/disable computation of the scan area with reference to selected paper size.
CT
settings
0: off (determine scan area based on original detection; default)
1: on (determine scan area based on paper size)
OHP- Use it to switch over the transparency mode temperature control setting.
TEMP
Decreases the fixing temperature to facilitate separation of transparencies from the fixing
roller.
0: 198 deg C (default); 1: 1983 deg C; 3: 183 deg C
OHP- Use it to enable/disable the transparency mode potential control mechanism.
CNT
settings
0: use the target value obtained from transparency mode (default)
1: do not execute potential control during transparency mode
FIX- Use it to select a start temperature for plain paper down sequence.
TMP1
If the user places priority on image quality, set it to '0'; on speed, to '2'.
settings:
0: 183 deg C; 1:178 deg C (default); 2: 173 deg C
TRSW-P- Use it to enable/disable the transfer current output correction mechanism for the trail edge of
B paper.
settings
0: on; 1: off (default)
SP- Use it to enable/disable the separation current output correction control mechanism.
MODE
settings
0: standard mode (default); 1: low-voltage mode
FTMP- Use it to select an appropriate stacking performance enhancement mode.
DWN
Decreases the fixing temperature to improve the performance of stacking in the finisher.
settings
0: off (default); 1: -5 deg C; 2: -10 deg C; 3; -15 deg C
COPIER > OPTION > BODY
Description
Chapter 17
Level
1
1
2
2
2
2
2
2
2
2
17-63