Canon imageRUNNER 7095 Service Manual page 280

8.11.22.3 Removing the Front Cover of
the Duplexing Unit
1) Remove the 4 screws [1] and the knob [2];
then, detach the front cover [3].
[3]
F-8-126
8.11.22.4 Removing the Duplex Left Feed
Motor
1) Remove the duplex feed fan unit.
2) Loosen the screw [1]; then, while pulling the
tension support plate [2] in the direction of the
arrow, tighten the screw [1] (to loosen the
tension of the belt [3]).
3) Disconnect the connector [4], and remove the
2 screws [5]; then, detach the duplex left feed
motor [6].
[3] [6]
[5]
F-8-127
8.11.22.5 Removing the Duplex Right
Feed Motor
1) Remove the front cover of the duplex unit. (4
screws, 3 knobs)
2) Loosen the screw [1]; then, while pulling the
tension support plate [2] in the direction of the
arrow, tighten the screw [1] (to loosen the
tension of the belt [3]).
[2] [1]
[1]
[1]
[4]
[2]
3) Disconnect the connector [4], and remove the
2 screws [5]; then, detach the duplex right feed
motor [6].
0010-9341
[3]
8.11.22.6 Removing the Reversing
Flapper Solenoid
1) Remove the duplexing unit from the main
body.
2) Remove the two screws [1], and disconnect the
0010-9346
connector [2]; then, detach the reversing
flapper solenoid [3].
8.11.22.7 Removing the Left Deck Feed
Sensor
1) Slide out the duplex unit assembly.
2) Remove the screw [1], and detach the sensor
base [2].
0010-9349
[5]
[6] [1]
[5]
[2]
F-8-128
[1] [1]
[2] [3]
F-8-129
[2]
[1]
F-8-130
Chapter 8
[4]
0010-9355
0010-9360
8-47