Canon imageRUNNER 7095 Service Manual page 65

Chapter 2
2) Match the 2 bosses [3] of the arm cover 3 [2]
with the Control panel arm unit [1], and fix it in
place with a screw (binding; M4X10) [4].
[3]
[2]
F-2-59
3) Route the control panel interface cable through
the Control panel arm unit [1], and fix it in
place with the edge saddle [3].
[2]
F-2-60
4) Hook the claw [2] of the Control panel arm unit
[1], and tighten the 4 screws (binding; M4X10)
[3] and 4 screws [4].
- Be sure to tighten the screws in the correct
order.
- Do not drop the screws.
[4]
[1]
[3]
F-2-61
2-18
[4]
[3]
[1]
[1]
[3]
[2]
[3]
5) Adjust the control panel interface cable [1] so
that the length [4] from the edge saddle [2] and
the marking [3] is about 5 cm, and fix it in place
using the edge saddle.
[4]
[3] [1]
F-2-62
6) Hook the claw [2] of the cover support plate
[1], and fix it in place using 2 screws (binding;
M4X10) [3].
[3] [1]
F-2-63
7) Open the DF, and lead the control panel
interface cable [2] along the arm cover 2 [1];
then, put the cover over the control panel arm
unit.
[2] [1]
F-2-64
[2]
[3] [2]