Canon imageRUNNER 7095 Service Manual page 471

CODE: jam code
P: source of paper
CNTR: reading of soft counter for source of paper
SIZE: paper size
The jam detail screen can only display jam codes that occur in the units shown below.
- Main unit
- ADF
- Paper deck
- Finisher
When a jam occurs in other units, the jam detail screen is not displayed, but you can specify a jam occur-
rence location (unit) using the jam-processing screen (in animation) displayed in the user screen.
Measures for a jam (when both of a finisher and stacker are installed)
A finisher and stacker share some jam codes.
For such jam codes, the jam detail screen always displays finisher information (illustrations, sensor num-
bers), but the jam might be actually occurring in the stacker.
Be sure to check the display of "location, category" ( "L" ) in the jam history screen to specify the unit
where the jam occurs.
<ERR>
No.: number indicating order of error occurrence (the higher the number, the older the error)
DATE: date of error occurrence
TIME1: time of error occurrence
TIME2: time of error recovery
CODE: error code
DTL: detail code (if none, '0000')
Code Description
01 right deck
02 left deck
03 cassette 3
04 cassette 4
07 side paper deck
08 manual feeder tray
09 duplexing assembly
0A inserter for finisher (upper)
0B inserter for finisher (lower)
60 for future use
61 for future use
F-17-10
Chapter 17
17-9