Mounting The Developing Assembly - Canon imageRUNNER 7095 Service Manual

- Check to be sure that the solvent is fully dry.
- Check to be sure that the one-way arm [1] of the
pre-transfer charging assembly is on the
eccentric cam [2].
[2]
F-2-43
15) Mount the double-feeding detection PCB
(transmitting).
16) Mount the primary charging assembly front
cover and the pre-transfer charging assembly
cover.
17) Close the front cover.

2.2.7 Mounting the Developing Assembly

1) Open the manual feeder tray cover.
2) Remove the tape [1]; then, remove the hopper
supply mouth cover [2].
F-2-44
[1]
0010-8950
[1]
[2]
3) Holding the developing assembly [1] as
shown, fit it in place in the machine.
When mounting the developing assembly, take
care not to hit against the developing cylinder [2].
[1]
F-2-45
4) Connect the connectors [1], [2].
Check to be sure that the connector will not be-
come disconnected. Poor contact will lead to
blank prints.
[1]
F-2-46
5) Mount the developing assembly locking plate
[1].
- 2 bosses [2]
- 6 screws (TP; M4X6; black) [3]
[3] [1]
[2]
F-2-47
Chapter 2
[2]
[2]
[3]
[2]
2-15