Mounting The Pickup Assembly; Mounting The Control Panel - Canon imageRUNNER 7095 Service Manual

12) Attach the connector cover [1].
- screw (RS tightening; M4X10) [2]
[2]
F-2-54

2.2.8 Mounting the Pickup Assembly

1) Shift the lever [1] in the direction of the arrow,
and remove the pickup roller release spacer [2].
[1]
F-2-55
2) Close the manual feeder tray unit.
3) Push the release button of the front deck (right)
and the cassette 3/4, and slide them out
halfway.
4) Slide out the cassette 3/4, and remove the
packing tape from where the host machine and
the cassette come into contact (left side of the
host machine and right side of cassette 4).
5) Open the upper right cover [1] and the lower
right cover [2], and remove the 3 pickup roller
release spacers [3].
MEMO:
If the deck/cassette is inside the machine, the
spacer is locked in place and cannot be removed;
be sure to slide the unit out halfway to unlock it.
[1]
6) Close the upper right cover and the lower right
cover.
7) Close the front deck (right) and the cassette 3/
4.
8) Press the release button of the front deck (left),
and slide out the deck.
9) Mount the included deck locking plate [1] to
the front deck (left).
0010-8957
- screw (RS tightening; M4X10; white) [2]
Front Deck (left)
10) Close the front deck (left).

2.2.9 Mounting the Control Panel

[2]
1) Remove the upper rear right cover [1].
- 3 screws [2]
[2]
[1]
[2]
[3]
F-2-56
[1]
[2]
F-2-57
[1]
F-2-58
Chapter 2
0011-4903
[2]
2-17