Canon imageRUNNER 7095 Service Manual page 63

Chapter 2
Check to be sure that the developing assembly
locking plate is free of a gap and displacement,
which are likely to cause image faults. (Especial-
ly, it must not be riding over the bosses found be-
low.)
When mounting the developing assembly locking
plate, take care not to trap the cable [1].
F-2-48
6) Slide out the 2 rails [1] of the pull-off unit.
[1]
F-2-49
7) Remove the tape from the pull-off unit.
8) Hold the pull-off unit [1] as follows, and hook
the 4 holes [3] of the pull-off unit on the 4
protrusions [2] of the rail.
[3] [2]
[2] [1]
F-2-50
2-16
[1]
[1]
[3]
9) Secure the pull-off unit in place with 2 screws
(binding; M3X4) [1] in place, and push in the
pull-off unit until it is locked in place.
[1]
F-2-51
10) Fit the reuse band [1] in the hole [2] of the
host machine.
[1]
F-2-52
11) Connect the connector [1].
F-2-53
[2]
[1]