Pre-Transfer Exposure Led; Separation Claw/Separation Claw Drive Assembly - Canon imageRUNNER 7095 Service Manual

Points to Note When Mounting
- The transfer/separation charging assembly is
equipped with a positioning boss on its front
and rear.
When mounting the assembly, be sure to hook the
bosses on the cut-offs in the stay.
- If the charging assembly cleaner is on the front
side, the home position detecting microswitch
can become damaged; be sure to set the
charging cleaner at the center.
Boss
F-7-107
Boss
F-7-108

7.10.15 Pre-Transfer Exposure LED

7.10.15.1 Removing the Pre-Transfer
Exposure LED
1) Slide out the pre-transfer charging assembly.
When placing the removed pretransfer charging
assembly, be sure to take care not to subject the
LED to impact.
Boss
Boss
0010-8878
2) Turn over the pre-transfer charging assembly,
and remove the 3 screws [1] found on the
bottom; then, detach the LED cover [2].
[2]
F-7-109
3) Disconnect the connector [1], and remove the

pre-transfer exposure LED [2].

[2]
F-7-110
7.10.16 Separation Claw/Separation Claw
Drive Assembly
7.10.16.1 Separation Claw/Separation
Claw Drive Assembly
1) Open the front cover.
2) Take out the process unit.
3) Remove the E-ring [1], and slide out the
separation claw holder shaft [2] to the front to
detach the separation holder [3].
[1]
F-7-111
Chapter 7
[1]
[1]
[2]
[3]
0010-8880
7-47