Table of Contents
Advertisement
CHAPTER 4 OPERATION
6.2.2
Controlling the Fixing Film Bias
The machine is equipped with a fixing film bias control mechanism which is controlled
by the CPU on the DC controller PCB. The fixing film bias is used to prevent displacement
of toner deposits; i.e., when the primary charging roller DC bias is applied, a bias of the
same polarity as the toner is applied to the fixing film so as to create a magnetic field be-
tween the paper and the film.
DC controller PCB
CPU
6.2.3
Fixing Heater Safety Mechanism
The fixing heater safety circuit is part of the DC controller PCB, and is used to monitor
the fixing temperature for an error at all times. If the output voltage for the main thermistor
or the sub thermistor reaches about 0.37 V or lower (about 310°C), the relay will be turned
off regardless of the state of the relay drive signal (RLYD) from the CPU to shut the power
to the fixing heater.
If the temperature of the fixing heater increases abnormally, on the other hand, to exceed
about 230°C, the thermal fuse will melt to cut the power to the fixing heater.
6.2.4
Detecting a Fault in the Fixing Assembly
The CPU on the DC controller PCB will identify a fault in the fixing assembly if any of
the following conditions (a through f) occurs; as a result,
• it will cut the power to the fixing heater.
• it will cause the relay drive signal (RYLD) to go '1' to turn off the relay and, at the
same time, will communicate the presence of a fault to the image processor PCB.
a. Overheating 1 (all conditions)
The CPU will identify overheating 1 if the main thermistor detects 230°C for 1 sec or
more continuously.
4-28
COPYRIGHT © 2001 CANON INC.
Chapter4.p65
Primary charging
roller
AC bias drive circuit
Primary charging
roller
DC bias drive circuit
F04-602-02
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
28
J205
Superposition
Photosensitive
J206
8/26/01, 3:44 PM
Rimary
charging
roller
drum
Fixing film
Advertisement
Table of Contents
Troubleshooting
