Canon imageRUNNER 7095 Service Manual page 527

*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
THICK- Use it to set potential control for heavy paper mode.
PR
settings
0: use the value determined at time of potential control for plain paper mode (default)
1: use the value determined at time of potential control for transparency mode
TEMP- Use it to select an appropriate fixing temperature.
TBL
settings
- if 200V model
0: 183 deg C 1: 193 deg C 2: 178 deg C 3: 173 deg C 4: 168 deg C
- if 208V/230V model
0: 193 deg C 1: 198 deg C 2: 188 deg C 3: 183 deg C 4: 178 deg C
DRM-H- Use it to enable/disable the continuous drum heater off mode.
SW
settings
0: continuous drum heater on (default)
1: check environment temperature every 2 hr, and turn off drum heater if absolute moisture
content is 9 g or less
DEV- Use it to set the forced developing assembly idle rotation mode. (before execution of black
IDLR band sequence at power-on)
settings
0: if 2,000 prints or more made on previous day and, in addition, absolute moisture content is
16 g or more (default); 1: at all times
BK-BD-1 Use it to set the month-based black band sequence mode (January to December).
to BK-
settings
BD-12
0: do not execute if absolute moisture content is less than 9 g; if 9 g or more, execute every 200
prints (default); 1: execute every 60 prints; 2: execute every 20 prints; 3: execute every 6 prints
PAPER- Use it to set the fixing temperature/pre-transfer assembly control mechanism to suit paper type
TY (inside/outside Japan).
0: control to suit destination (A, AB, inch, AB/inch)
1: assume use of paper for Japan; 2: assume use of paper for outside Japan
SMTPTX Use it to change the SMTP transmission port number.
PN
settings
0 to 6535 (default: 25)
SMTPRX Use it to change the SMTP transmission port number.
PN
settings
0 to 65535 (default: 25)
POP3PN Use it to change the POP reception port number.
settings
0 to 6535 (default: 110)
RUI-DSP Use it to set the copier function option switch of the remote UI (for compliance with disability
laws).
settings
0: do not show copier screen for remote UI (default); 1: display
ORG- Use it to set special paper sizes (not recognized when the ADF is in use).
LGL
settings:
*
0: Legal-R (default); 1: Bolivian Officio-R; 2: Argentine Officio-R; 3: Argentine Legal-R; 4:
Mexican Officio-R
**
0: Legal-R; 1: Foolscap-R; 2: Officio-R; 3: Folio-R; 4: Australian Foolscap-R; 5: Ecuadorian
Officio-R; 6: Bolivian Office-R; 7: Argentine Officio-R; 8: Argentine Legal-R; 9: Government
Legal-R; 10: Mexican-R
COPIER > OPTION > BODY
Description
Chapter 17
Level
2
2
2
2
2
2
2
2
2
2
2
17-65