Canon imageRUNNER 7095 Service Manual page 61

Chapter 2
9) Disconnect the connector [1], and release the
locking lever [2] of the primary charging
assembly to remove the primary charging
assembly [3].
Clean the primary charging wire and the grid
wire using alcohol.
[2]
F-2-39
All solvent must be fully dry before fitting the
parts back in place.
10) Remove the pre-transfer charging assembly
front cover [1].
- screw [2]
[1]
F-2-40
11) If a double-feeding
(transmitting) [3] is found, disconnect the 2
connectors [1] and remove the screw [2], and
open the PCB in the direction of the arrow.
2-14
[1]
[3]
[2]
detection PCB
[2]
[1]
F-2-41
12) Disconnect the connector [1], and release the
locking lever [2] of the pre-transfer charging
assembly; then, remove the pre-transfer
charging assembly [3].
Clean the pre-transfer charging assembly using
alcohol.
[1]
[3]
F-2-42
13) While keeping it unlocked, fit in the primary
charging assembly, and connect the connector.
Check to make sure that the solvent is fully dry.
14) While keeping it unlocked, fit the pre-transfer
charging assembly in place, and connect the
connector.
[3]
[2]