Canon imageRUNNER 7095 Service Manual page 503

Notes:
At times, the value indicated for the following items may differ before and after input (maximum of +/-3).
The fact has to do with how the indication values are computed, and will not affect the operation of the
machine.
Sub item
HVT-DE Use it to enter the offset value for the developing high-voltage output of the high-voltage unit.
range: -50 to 50
Be sure to enter the value indicated on the label attached to the new unit if you have replace
the high-voltage unit.
Be sure to enter the value indicated on the service label if you have replaced the DC controller
PCB or initialized the RAM.
D-HV-DE Use it to enter the offset value for the developing high-voltage of the DC controller PCB.
range: -100 to 100
Be sure to enter the value indicated on the label attached to the new PCB if you have replaced
the DC controller PCB.
Be sure to enter the value indicated on the service label if you have initialized the RAM on the
DC controller PCB.
OFFSET Use it to enter the high-voltage D/A output offset value for the developing AC bias.
DA
range: -100 to 100
Be sure to enter the value indicated on the label attached to the new PCB if you have replaced
the DC controller PCB.
Be sure to enter the value indicated on the service label if you have initialized the RAM on the
DC controller PCB.
OFFSET Use it to adjust the offset value of the developing AC bias.
AC
range: -120 to 120
Be sure to enter the value indicated on the label attached to the new unit if you have replace
the high-voltage unit.
Be sure to enter the value indicated on the service label if you have replaced the DC controller
PCB or initialized the RAM.
<DENS>
Sub item
DENS- Use it to correct the image density.
ADJ
Correct the F-value table if fogging occurs or a faint image occurs in a high-density area.
A higher setting will reduce faint images. A lower setting will reduce fogging.
range: 1 to 9
Be sure to enter the value indicated on the service label if you have replaced the DC controller
PCB or initialized the RAM.
COPIER > ADJUST > DEVELOP
Description
T-17-21
COPIER > ADJUST > DENS
Description
Chapter 17
Level
1
1
1
1
Level
1
17-41