Manual Pickup Roller; Manual Feed Roller - Canon imageRUNNER 7095 Service Manual

Chapter 8
4) Release the lever [1] in upward direction; then,
slide out the pull-off roller unit [2], and remove
the 2 screws [3].
[3]
[1]
F-8-75
5) Remove the pull-off roller unit [1] in the
direction of the arrow.
[1]
F-8-76

8.11.9 Manual Pickup Roller

8.11.9.1 Removing the Pickup Roller
1) Open the manual tray paper guide.
2) Remove the left/right stop rings [1] (two each),
shutters [2] (two each), spacers [3] (two each),
and rolls [4] (two each).
[1] [2]
F-8-77
If the multifeeder is used during installation or if
the multifeeder has not been used for a long time,
pickup can fail. If such happens, detach the pro-
tective sheet from the sponge roller, and dry wipe
the sponge roller.
8-38
[2]
[1]
[2]
[3]
[4]
[4]
[3]
8.11.9.2 Mounting the Pickup Roller
Mount the pickup roller by reversing the steps
used to remove it with the following in mind:
- The front pickup roller and the rear pickup roller
are not interchangeable.
- The front pickup roller is identified by its silver-
colored collar.
When mounting the pickup roller [1] to the
pickup assembly, be sure that the round
marking [2] on the collar (silver) is toward the
machine's front,
Direction of
rotation
[1]
- The rear pickup roller is identified by its gold
collar.
When mounting the pickup roller [3] to the
pickup assembly, be sure that the round
marking [4] on the side of the roller and the
round marking [5] on its collar (gold) are
toward the machine's rear.
Direction of
rotation
[3]
0010-8992

8.11.10 Manual Feed Roller

8.11.10.1 Removing the Feeding Roller
1) Remove the pickup roller, and remove the stop
ring.
2) Remove the two screws [1], and detach the
manual feed tray guide [2].
[2]
front of
Collar (silver)
the machine
F-8-78
[4]
[5]
rear of
Collar (gold)
the machine
F-8-79
[1] [2] [1]
F-8-80
0010-8993
0010-8994