Upper Separation Claw; Lower Separation Claw - Canon imageRUNNER 7095 Service Manual

4) Disconnect the 2 connectors [1], and remove
the 2 screws [2]; then, detach the delivery speed
switching clutch [3].
[2]
[2]
[3]
F-9-73
When detaching the delivery speed switching
clutch, take care not to lose the bearings on both
ends of the clutch shaft and the washer at the rear.

9.5.18 Upper Separation Claw

9.5.18.1 Removing the Upper Separation
Claw
1) Slide out the fixing/feeding unit from the main
body.
2) Release the spring [1] used to open the fixing/
delivery assembly; then, detach the upper
separation claw [2].
[1]
F-9-74
[1]
[2]

9.5.19 Lower Separation Claw

9.5.19.1 Removing the Lower Separation
Claw
1) Remove the fixing assembly from the main
body.
2) Remove the two screws, and detach the lower
separation claw assembly together with the
support plate.
3) Remove the spring [1] from the lower
separation claw.
4) Remove the three screws [2], and detach the
lower separation claw support plate [3]; then,
detach the separation claw.
0010-9551
[2]
[1]
F-9-75
[3]
[2]
F-9-76
Chapter 9
0010-9554
9-23