Manual Separation Roller; Manual Feed Tray Paper Sensor - Canon imageRUNNER 7095 Service Manual

Chapter 8
8.11.10.4 Mounting the multiple curling
prevention roller
1) Set the multiple curling prevention roller
assembly to the main body.
2) Mount the rear fixing plate 2 and the rear fixing
plate 1 in the order indicated; then, secure them
in place with the mounting screw [3].
Rear fixing plate 2
F-8-87
When mounting the multiple curling prevention
roller, hook the two claws of the rear fixing plate
2 on the three holes in the rear side plate; then,
mount the rear fixing plate 1 to secure.

8.11.11 Manual Separation Roller

8.11.11.1 Removing the Separation Roller
[3]
[1]
[2]
F-8-88
When removing the separation roller, pay atten-
tion to the bushing at the front.
It will slip off.
Initially, the urethane sponge of the part is pink,
and changes over time (accelerated if exposed to
light).
Its tone will change from pink to orange and to
yellow; it is a general characteristic of urethane
sponge, and no physical deterioration (in per-
8-40
0010-9007
0010-9031
[4] [1]
formance) exists because of changes in color, and
the part is not identified by color.
Urethane sponge pieces
F-8-89

8.11.12 Manual Feed Tray paper sensor

8.11.12.1 Removing the Manual Feed
Tray Paper Sensor
1) Open the manual feed tray unit, and remove the
door tape from the machine side.
2) Remove the mounting screw [1], and detach
the solenoid cover [3]. (A claw [2] is hooked on
the L-shaped opening; pull it down lightly, and
move it as if to open it.)
[3]
[1]
[2]
F-8-90
3) Disconnect the connector [1].
4) Remove heater mounting screw [2], and detach
the pickup roller releasing solenoid [3] together
with the support plate.
[2]
[1] [3]
F-8-91
0010-9032