Unpacking And Installation; Points To Note When Turning On/Off The Main Power; Unpacking - Canon imageRUNNER 7095 Service Manual

2.2 Unpacking and Installation

2.2.1 Points to Note When Turning On/Off
the Main Power
Turning Off the Main Power (host
machine)
Be sure to go through the following when turning
off the main power to protect the hard disk:
1. Hold down the control panel power switch for
3 sec or more.
2. Go through the instructions on the shut-down
sequence screen so that the main switch may be
turned off.
3. Turn off the main power switch.
4. Disconnect the power cable (for the power
outlet).
Order of Turning On/Off the Machines
(host machine + accessories)
If a delivery accessory (e.g., finisher) is installed,
be sure to respect the following order when turn-
ing them on/off:
<Turning On the Power>
1. high-capacity stacker, finisher (either)
2. professional puncher (non-Japanese model
only)
3. host machine
<Turning Off the Power>
1. host machine
2. high-capacity stacker, finisher (either)
3. professional puncher (non-Japanese only)
- Failure to observe the order of turning on the
machines prevents the host machine from
recognizing the accessories.
- Failure to observe the order of turning off the
machines will lead to an error ('E730' or
'E503').

2.2.2 Unpacking

1) Unpack the machine.
Open the plastic bag.
2) Remove the grip cover (rear) [1] found on the
right side of the machine using a flat-blade
0011-4949
screwdriver, and shift up the grip [2] found at
the rear.
3) Take out the grip [1] from the contents box.
4) Open the upper right cover, and slide the face
over (small) [1] toward the rear to detach; then,
remove the other face cover (large) [2].
Fit the grip [3] removed in step 3) into the front
of the machine.
Chapter 2
[2]
[1]
F-2-6
[1]
F-2-7
[1]
[2]
F-2-8
0010-8941
[3]
2-7