Option (Machine Settings Mode); Copier; Copier Items - Canon imageRUNNER 7095 Service Manual
Hide thumbs
Also See for imageRUNNER 7095:
- Brochure & specs (8 pages) ,
- Specifications (4 pages) ,
- Driver manual (180 pages)
Table of Contents
Advertisement
Chapter 17
17.6 OPTION (Machine Settings Mode)
17.6.1 COPIER
17.6.1.1 COPIER Items
<BODY>
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
PO-CNT Use it to enable/disable the potential control mechanism.
settings
0: off; 1: on (default)
TRNSG-
Use it to select an appropriate transfer guide bias control mode.
SW
settings
0: absolute moisture content (if 22 g or higher, 200 V; otherwise, 600 V)
1: fixed to 600 V
2: fixed to 200 V
3: if absolute water content of 18 g or more, 200 V; otherwise, 600 V (default)
4: if absolute waste content of 14 g or more, 200 V; otherwise, 600 V
MODEL-
Use it to switch over the display of default magnifications and ADF original size detection.
SZ
settings
0: AB (6R5E) (default) 1: INCH (5R4E)
2: A (3R3E) 3: AB/INCH (6R5E)
FIX-
Use it to set the down sequence start temperature for heavy paper.
TEMP
settings
0: 194 deg C; 1: 189 deg C (default); 2: 184 deg C
FUZZY
Use it to enable/disable the fuzzy control mechanism and make environment settings.
Affects the charging current level for pre-transfer, transfer, and separation.
- if set to '1' thorough '3', the mechanism will be free of the environment sensor readings.
settings
0: fuzzy control on (default)
1: low humidity environment mode (current level lower than standard)
2: normal humidity environment mode
3: high humidity environment mode (current level higher than standard)
CNT-W/
Use it to enable/disable the density variation mode mechanism for a printing session (PDL
PR
input).
settings
0: correct target value to enable density variation during printing (default)
1: disable density variation during printing
CONFIG Use it to select multiple firmware items on the hard disk for changing settings (country/area,
language, destination, paper size series).
<Procedure>
1) Select <CONFIG>.
2) Select the item to change.
3) Press the +/- key. (Each press changes the setting.)
4) Have all settings for all items, and press the OK key.
5) Turn off and then back on the main power switch.
XXYYZZAA
XX: country (e.g., JP=Japan)
YY: language (e.g., ja=Japanese)
ZZ: destination (e.g., 00=Canon)
AA: paper size series (00=AB; 01=inch; 02=A; 03=inch/AB)
TR-SP-
Use it to change the transfer/separation output settings for pickup from the right deck.
C1
settings
0: plain paper (default); 1: recycled paper; 2: tracing paper
17-60
T-17-48
COPIER > OPTION > BODY
Description
0011-6021
Level
1
1
1
1
1
1
1
1
Advertisement
Chapters
Table of Contents
