Location Of The Solenoids; Position Of The Fixing Web Solenoid (Sl2); Position Of The Delivery Flapper Solenoid (Sl3); Position The Fixing/Feeder Unit Locking Solenoid (Sl4) - Canon imageRUNNER 7095 Service Manual

14.8.9 Location of the solenoids

SL6
SL3
SL2
SL8
SL11
F-14-60
SL2 : Fixing web solenoid
SL3 : Delivery flapper solenoid
SL4 : Fixing/feeder unit locking solenoid
SL6 : Manual feed pickup latch solenoid
SL7 : Deck (right) pickup solenoid
SL8 : Deck (left) pickup solenoid
SL9 : Cassette 3 pickup solenoid
SL10: Cassette 4 pickup solenoid
SL11: Reversing flapper solenoid
14.8.10 Position of the Fixing Web
Solenoid (SL2)
a. If the Fixing Web Is New
Use the position of the solenoid [1] using the
screw [2] so that the travel of the drive lever is
8.2 mm.
[1]
[2]
F-14-61
SL4
SL7
SL9
SL10
8.2mm
b. If the Fixing Web Is Not New
Before removing the solenoid, check the
0011-8945
position [A] of the drive lever when the
solenoid [1] is ON. After replacing the
solenoid, make adjustments using the screw [2]
so that the position of the drive lever is the same
(when the solenoid is ON).
[1]
[2]
14.8.11 Position of the Delivery Flapper
Solenoid (SL3)
Use the screw [2] to adjust the position of the so-
lenoid [1] so that the drive lever is fully pushed
when the solenoid is ON (i.e., when the steel core
is drawn).
Fully pushed.
14.8.12 Position the Fixing/Feeder Unit
0010-9348
Locking Solenoid (SL4)
Use the screw [3] to adjust the position of the so-
lenoid [1] so that the locking lever [2] is 10.5 -/+
0.5 mm away from the frame when the solenoid
is ON (i.e., when the steel core is drawn).
[3]
Chapter 14
A
F-14-62
[1]
[2]
F-14-63
[1]
[2]
F-14-64
0010-9350
0010-9351
14-27