Canon imageRUNNER 7095 Service Manual page 66

When putting the arm cover 2 in place, be sure it
is correctly oriented in relation to the plate [1].
[1]
F-2-65
8) Tighten the screw (binding; M4X10) [1].
When tightening the screw [1], be sure to hold
down the arm cover 2.
F-2-66
9) Tighten the screw (binding; M4X10) [1].
Be sure to tighten the screw at an angle.
F-2-67
[1]
[1]
[1]
10) Hook the claw [1] of the arm unit on the hole
[2] in the Control panel arm unit.
[1]
[2]
F-2-68
11) Turn it in the direction of the arrow until the
screw hole [1] of the arm unit matches the hole
in the Control panel arm unit.
F-2-69
12) Tighten the screw (binding; M4X14) [2] and
then the 4 screws [3] of the arm unit [1].
- Be sure to tighten the screws in the correct
order.
- Be sure to tighten the screws while keeping the
arm in the direction of the arrow to avoid
contact with the extension tray.
F-2-70
Chapter 2
[1]
[3]
[2]
[3]
[1]
2-19