Canon imageRUNNER 7095 Service Manual page 451

YY Description
*5
*6
A file system error has
05
occurred.
*7
*8
00
The HDD has poor
01
*9 contact, or a system
02
error has occurred.
04
11 The HDD has poor
*10
21 contact.
The ongoing write
13
*11 operation has been
25
interrupted.
10
12
A system error or a
14
*12 packet error has been
22
detected.
23
24
- Enter CHK-TYPE in question (for the partition), and execute HD-CLEAR;
then, turn off and then back on the power.
- Replace the HDD, and reinstall the system software.
The machine is designed so that execution of HD-CLEAR is not possible in
service mode (so as to prevent loss of information, e.g., address book, filter
information).
- Ask the user to download the address book data using a remote UI.
- In service mode, start download mode, and execute full formatting using
the SST and reinstall the system software; then, turn off and then back on the
power.
- Set CHK-TYPE=1, 2, 3, 5, and execute HD-CLEAR; then, turn off and
then back on the power.
- Replace the HDD, and reinstall the system software.
The recovery operation for the boot partition is not possible without the use
of the SST in save mode.
- Start up in safe mode, and execute full formatting using the SST and
reinstall the system software; then, turn off and back on the power.
- Replace the HDD, and reinstall the system software.
- Check the cable and the power cord.
- Start up in safe mode, and execute full formatting using the SST and
reinstall the system software; then, turn off and back on the power.
- Replace the HDD, and reinstall the system software.
- Check the cable and the power cord.
- Replace the HDD, and reinstall the system software.
There is a strong possibility of damage in the file data (e.g., Box) stored on
the HDD.
- Set the partition number in question for CHK-TYPE, and execute HD-
CHECK; then, turn off and back on the power.
- Set the partition number in question for CHK-TYPE, and execute HD-
CLEAR; then, turn off and back on the power.
(In the case of BOOTDEV, BOOTDEV2 or APL_SEND, execute
reformatting using the SST, and reinstall the system software.)
- Replace the HDD, and reinstall the system software.
- Start up in safe mode, and perform full formatting using the SST and
reinstall the system software; then, turn off and back on the power.
- Replace the HDD, and reinstall the system software.
Action
Chapter 16
16-17