19) Mount the card reader base to the upper front
cover unit.
F-2-138
20) Mount the upper front cover unit lower cover
to the upper front cover unit.
Take care not to trap the cable by the upper front
cover unit and the upper front cover unit lower
cover.
21) Lead the cable [1] of the card reader to the
front of the upper front cover unit [2], and
mount the upper front cover unit [2] to the
machine.
- 3 screws [3]
F-2-139
22) Connect the connector [1] of the machine and
the relay connector [2] of the card reader.
[1]
F-2-140
[2]
[1]
[3]
[2]
[1]
[2]
23) Mount the covers by going through the steps
used to remove them but only in reverse:
- mount the upper inside cover.
- connect the connector.
- mount the process unit cover.
- mount the primary charging assembly front
cover.
- push in the fixing transport unit.
- close the front cover and the hopper cover.
24) Connect the machine's power plug, and turn
on the main power switch.
Chapter 2
2-35