Canon imageRUNNER 7095 Service Manual page 164

Chapter 5
5.4.13.5 Adjusting the Position of the No.
1/No. 2 Mirror Base
1) Arrange the mirror positioning tool (FY9-
3009-040) so that it is ready for use in the
machine (by changing the pin position; REAR).
[C]
[A]
F-5-167
2) Arrange the mirror positioning tool so that it is
ready for use in the machine (by changing the
pin position; FRONT).
[B]
[A]
[B]
F-5-168
5-46
[B]
[A]
[B]
[C]
[A]
3) Fit the pins of the mirror positioning tool (front
[2]; rear [3]) into the appropriate holes of the
No. 1/No. 2 mirror base).
0011-9470
4) Secure the end of the cable that has temporarily
been fixed in place on the hook of the reader
unit frame.
5) Fully tighten the screws on the cable fixing
plate both at the front and the rear.
6) Detach the mirror positioning tool (FRONT,
REAR).
7) Put the detached parts back on by reversing the
foregoing steps.
[1]
F-5-169
[3]
[2]
F-5-170