Mounting The Charging Assembly - Canon imageRUNNER 7095 Service Manual

Chapter 2
9) Remove the screw [1], and detach the pretrans-
fer charging assembly cover [2].
[2]
F-2-30
10) Disconnect the connector [1], and release the
locking lever [3] of the pre-transfer charging
assembly [2]; then, take out the pre-transfer
charging assembly.
Using alcohol, clean the pre-transfer charging
wire.
[1]
F-2-31
11) With the lock released, slide in the primary
charging assembly, and connect the connector.
Check to make sure that the solvent is fully dry.
2-12
[1]
[3]
[2]
12) With the lock released, slide in the pretransfer
charging assembly, and connect the connector.
[2]
F-2-32
- Check to make sure that the solvent is fully dry.
- Check to make sure that the one-way arm [1] of
the pretransfer charging assembly is on the
eccentric cam [2].
13) Mount the primary charging assembly cover
and the pre-transfer charging assembly cover
with a screw (1 pc. each).
14) Close the front cover.

2.2.6 Mounting the Charging Assembly

1) Remove the transfer separation charging
assembly front cover [1].
- screw [2]
[2]
F-2-33
[1]
0011-9510
[1]