Sub Thermistor; Thermal Switch - Canon imageRUNNER 7095 Service Manual

9.5.7 Sub Thermistor

9.5.7.1 Removing the Sub Thermistor
1) Slide out the fixing assembly.
2) Remove the fixing web and the oil pan.
3) Remove the fixing harness cover.
4) Disconnect the connector [1] and remove the
screw [2]; then, detach the sub thermistor
assembly [3].
[1]
F-9-40
5) Remove the screw [1], and detach the sub
thermistor [2].
F-9-41

9.5.8 Thermal Switch

9.5.8.1 Removing the Thermal Switch
Unit
1) Remove the fixing assembly.
2) Remove the fixing web; then, remove the 2
screws [1] and the oil pan [2], and detach the
fixing harness cover [3].
[1]
[2]
F-9-42
[2]
[3]
[2]
[1]
[1]
[3]
3) Remove the faston [1], and remove the 2
screws [2]; then, detach the electrode assembly
[3] and the thermal switch holder [4].
0010-9448
[3]
4) Remove the 4 screws [1], and detach the
thermal switch unit [2].
[1]
9.5.8.2 Mounting the Thermal Switch Unit
0010-9450
- When mounting the thermal switch [1], be sure
that it is in contact with the fixing roller [2] as
shown.
- The thermal switch must be replaced as the
thermal switch unit.
- Do not use again the thermal switch wolse
contact point become open.
[2] [1] [4] [2]
F-9-43
[1]
[2]
F-9-44
[2]
[1]
F-9-45
Chapter 9
0010-9451
9-17