Jam Code - Canon imageRUNNER 7095 Service Manual

Chapter 16

16.3 Jam Code

16.3.1 Jam Code (printer)
Code Jam type
01xx delay jam
02xx stationary jam
0Axx power-on residual jam
0Bxx door open jam
0C00 double-feeding
Code Sensor type
xx01 right deck pickup sensor
xx02 left deck pickup sensor
xx03 cassette 3 pickup sensor
xx04 cassette 4 pickup sensor
xx05 vertical path 1 paper sensor
xx06 vertical path 2 paper sensor
xx07 vertical path 3 paper sensor
xx08 vertical path 4 paper sensor
xx09 registration roller sensor
xx0A fixing claw jam sensor
xx0B inside delivery sensor
xx0C outside delivery sensor
xx0D fixing feed unit outlet sensor
16.3.2 Jam Code (DADF-Q1)
<iR7105/7095>
Code Sensor type
0001 separation delay
0002 pickup delay
0003 pickup stationary 1 S3
0004 pickup stationary 2 S2
0005 reversal delay
0006 reversal stationary
0007 delivery delay
16-18
T-16-5
Sensor type
See the table
double-feeding sensor (reception)
Sensor
No.
PS20
PS25
PS37
PS42
PS47
PS49
PS41
PS46
PS5
PS65
PS9
PS10
PS11
T-16-6
Sensor No. Description
S4 At time of separation, the separation sensor does not detect the original
after it has been moved a specific distance (221 mm) following the start
of the separation motor.
S4,S2 At time of separation, the pre-registration roller sensor does not detect the
original after it has been moved a specific distance (93 mm) following the
detection of its lead edge by the separation sensor.
At time of pickup, the post-registration sensor does not detect the original
after it has been moved a specific distance (40 mm) following the start of
the reversal motor.
At time of pickup, the pre-registration roller sensor detects the original
after it has been moved a specific distance (330 mm if small; 660 mm if
large) following the start of the reversal motor.
S1 At time of reversal, the reversal sensor does not detect the original after
it has been moved a specific distance (104 mm) from the platen roller.
S1 At time of reversal, the reversal sensor detects the original after it has
been moved a specific distance (original length x 1.5 mm) following
arching operation.
PI13 At time of delivery, the delivery sensor does not detect the original after
it has been moved a specific distance (631 mm - original length)
following the start of the belt motor.
Code Sensor type
xx0F duplexing reversal sensor
xx10 duplexing outlet sensor
xx11 pre-confluence sensor
xx12 post-confluence sensor
xx13 left deck feed sensor
xx14 right deck feed sensor
xx15 side paper deck feed sensor
xx16 multifeeder curl-removal sensor
xx17 side paper deck pickup sensor
xx18 image write start sensor
xx19 manual feeder feed sensor
xx1A fixing inlet sensor
0011-5508
Sensor
No.
PS65
Sensor
No.
PS12
PS61
PS14
PS15
PS26
PS27
PS106
PS68
PS101
PS60
PS35
PS63
0011-5512