Link Aggregation Control Protocol (Lacp) Commands; Lacp Port-Priority - Cisco Sx350 Cli Manual

Link Aggregation Control Protocol (LACP)
Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
1

35.1 lacp port-priority

To set the physical port priority, use the lacp port-priority Interface (Ethernet)
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
value
lacp port-priority
no lacp port-priority
Parameters
value—Specifies the port priority. (Range: 1–65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example sets the priority of
switchxxxxxx(config)#
switchxxxxxx(config-if)#
gi1
interface gi16
lacp port-priority 247
35
6.
755