Ipv6 Mld Snooping Vlan - Cisco Catalyst Blade Switch 3130 Reference Manual

ipv6 mld snooping vlan

ipv6 mld snooping vlan
Use the ipv6 mld snooping vlan global configuration command on the switch stack or on a standalone
switch to configure IP version 6 (IPv6) Multicast Listener Discovery (MLD) snooping parameters on the
VLAN interface. Use the no form of this command to reset the parameters to the default settings.
Note This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch.
Syntax Description
vlan vlan-id
immediate-leave
mrouter interface
static ipv6-multicast-address
interface interface-id
Command Default
MLD snooping Immediate-Leave processing is disabled.
By default, there are no static IPv6 multicast groups.
By default, there are no multicast router ports.
Command Modes
Global configuration
Command History Release
12.2(40)EX1
Usage Guidelines
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
You should only configure the Immediate-Leave feature when there is only one receiver on every port in
the VLAN. The configuration is saved in NVRAM.
The static keyword is used for configuring the MLD member ports statically.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-220
ipv6 mld snooping vlan vlan-id [immediate-leave | mrouter interface interface-id | static
ipv6-multicast-address interface interface-id]
no ipv6 mld snooping vlan vlan-id [immediate-leave | mrouter interface interface-id | static
ip-address interface interface-id]
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
Specify a VLAN number. The range is 1 to 1001 and 1006 to 4094.
(Optional) Enable MLD Immediate-Leave processing on a VLAN
interface. Use the no form of the command to disable the Immediate
Leave feature on the interface.
(Optional) Configure a multicast router port. The no form of the
command removes the configuration.
(Optional) Configure a multicast group with the specified IPv6
multicast address.
Add a Layer 2 port to the group. The mrouter or static interface can be
a physical port or a port-channel interface in the range of 1 to 48.
OL-13271-01