Table of Contents
Advertisement
Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide
console(config-cmap)# exit
console(config)# policy-map p1
console(config-pmap)# class c1
Console(config-pmap-c)#
41.12 police
Use the police Policy-map Class Configuration mode command to define the
policer for classified traffic. This defines another group of actions for the policy
map (per class map).
This command is used after the
Use the no form of this command to remove a policer.
This command is only available when QoS is in advanced mode.
Syntax
police
committed-rate-kbps committed-burst-byte [exceed-action {drop |
policed-dscp-transmit}]
no police
Parameters
•
committed-rate-kbps—Specifies the average traffic rate (CIR) in kbits per
second (bps). (Range: 100–10000000)
•
committed-burst-byte—Specifies the normal burst size (CBS) in bytes.
(Range: 3000–19173960)
•
exceed-action {drop | policed-dscp-transmit}—Specifies the action taken
when the rate is exceeded. The possible values are:
-
drop—Drops the packet.
-
policed-dscp-transmit—Remarks the packet DSCP, according to the
policed-DSCP map as configured by the qos map policed-dscp Global
Configuration mode command.
Default Usage
N/A
56
set dscp
policy-map
and
class
commands.
41
569
Advertisement
Table of Contents
