Removing the fuser oil bottle
Removing the fuser oil bottle
Prepare procedure on the operator panel
[167]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select the 'Changing consumables' 'Replace fuser oil bottle' menu on the op-
erator panel.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under
'Work-steps': see
To remove the fuser oil bottle
[168]
Proceed as follows:
1.
Open the center door at the back of the printing system.
2.
Open new fuser oil bottle packaging. Use a knife to make a cross-cut in the
seal and prepare the fuser oil bottle.
[432]
3.
[433]
4.
320
Chapter 8 Replacing consumables
Explanation of icons on page
118.
Swivel out fuser oil bottle hold-
er with the empty fuser oil bot-
tle.
Open the interlock flap and dis-
connect the oil suction tube
from the fuser oil bottle. Wipe
away any residual oil from the
tube end on the bottle opening.