Table of Contents
Advertisement
Remove heater
Remove heater
Caution:
Observe the safety directives in the section
overview on page
To prepare for removing the heating element
[204]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button:
2.
On the operator panel, select the 'VarioStream' -> 'Changing consumables' ->
'Replace heater' menu.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under 'Work-steps':
See
Removing the heating element
[205]
Proceed as follows:
1.
Open the front and side door of the fuser station.
[504]
Caution
During operation, the components in the fuser station reach a surface tem-
perature of approximately 230
burns.
Do not touch any parts behind the safety covers identified with this icon:
[505]
372
Chapter 9 Replacing expendables
371.
Explanation of icons on page
Replacing the heating element -
118.
o
C. Touching the components can cause
Advertisement
Table of Contents
