Inserting the cleaning brush
Caution:
Observe the safety directives in the section
overview on page
Inserting the cleaning brush
[221]
Proceed as follows:
1.
Hold the new brush at the end that has no slit.
[585]
2.
3.
Check that the cleaning brush turns with its drive. If the cleaning brush is
correctly inserted, and is turned slightly, you will feel the flywheel mass of
the drive.
4.
Secure cleaning brush in this position.
5.
Run in the cover cap insert taper in the front brush opening and push as far
as the system casing. The cover cap must fit snugly over everything.
[586]
6.
407.
Inserting the cleaning brush
Replacing the cleaning brush —
Insert the new cleaning brush
into the opening, push to the
back and turn slightly to click
the fit-in key on the rear axis
into the slot on the cleaning
brush (check that the cleaning
brush rotates).
Press the cover cap with the
cleaning brush against the
opening and tighten both
knurled screws of the brush
cover cap.
411