Table of Contents
Advertisement
Manual roll replacement before paper end or without external paper end light barrier
Manual roll replacement before paper end or without
external paper end light barrier
Introduction
A manual roll replacement may be necessary for the following reasons:
On a synchronized twin or triplex printing system, you want to replace the roll
before the end of the paper or
the printing system does not have an external paper end light barrier.
Attention:
There must be sufficient paper on the paper roll on the first printer to allow the
paper web to be conveyed twice through the entire printing system (approx. 50 x
12" sheets).
Note:
The control box 'Automatic start' must be deactivated in the menu 'Configuration' ->
'Printing system' -> 'Paper end functions' (see
'Automatic start' on page
Manual roll replacement
[113]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Click on the 'Start' button in the 'Configuration' -> 'Printing system' -> 'Pa-
per end functions' menu.
3.
Click 'Ready'.
The printing system is switched to the 'Ready' status. The sheets, which
have left the first printer at 'Stop', but have not yet run through the second
printer, are now printed and fused. Then the progress display jumps to the
'Mark' mark.
4.
Affix new paper web (see
5.
After you have affixed the paper web (including 'NPRO'), click the 'End'
button.
204) to allow you to start the roll replacement manually.
Affixing the paper web on page
Activate/deactivate function
205).
203
Advertisement
Table of Contents
