Table of Contents
Advertisement
Proceed as follows:
[340]
5.
[341]
6.
To install the plastic strips
[138]
Proceed as follows:
[342]
1.
2.
Close the door in front of the photoconductor drum.
3.
Close the right door at the front of the printing system.
4.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
Clean plastic strips
Remove the plastic strips from
the mounting.
Clean the plastic strips with a
soft paper towel.
Push the plastic strips into the
mounting.
263
Advertisement
Table of Contents
