Table of Contents
Advertisement
Install photoconductor drum
Proceed as follows:
[574]
4.
5.
Attach clamping screw and secure tightly.
[575]
6.
7.
Close both doors at the front and the cover of the printing system.
8.
Select the type of inserted photoconductor drum (DRUM TYPE:).
9.
Indicate on the operator panel whether a new photoconductor drum has
been inserted:
In both cases, the message on the operator panel is automatically deleted,
and the replacement of the pressure roller is recorded in the 'Consumables
history' menu.
10.
Click the 'OK' button on the operator panel to complete the procedure:
The photoconductor drum is run in.
All units of the printing system are inspected (duration around 2-3 minutes),
before the printing system is switched to the 'Ready' status.
404
Chapter 9 Replacing expendables
'Yes'
The consumable counter is reset.
'No', if the photoconductor drum is not replaced, but instead just cleaned,
for example.
The consumable counter is not reset.
Push the holding flange back on
the flange shafts.
Align the flange mark to its as-
sociated mark on the flange
shaft.
Swivel on the door in front of
the photoconductor drum and
close the lever.
Advertisement
Table of Contents
