Table of Contents
Advertisement
Activate/deactivate function 'Automatic start'
Activate/deactivate function 'Automatic start'
Introduction
If the printing system should advise the roll change automatically, function
'Automatic start' must be activated in the 'Configuration' -> 'Printing system' ->
'Paper end functions' menu.
If you want to carry out the roll replacement manually, function 'Automatic start'
must be deactivated in the 'Configuration' ->'Printing system' -> 'Paper end
functions' menu.
To activate/deactivate function 'Automatic start'
[114]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Activate/deactivate function 'Automatic start' in the 'Configuration' ->
'Printing system' -> 'Paper end functions' menu.
The printing system is switched to the 'Ready' status. The sheets, which
have left the first printer at 'Stop', but have not yet run through the second
printer, are now printed and fused. Then the progress display jumps to the
'Mark' mark.
3.
Click 'Ready'.
204
Chapter 6 Operating the printing system
Advertisement
Table of Contents
