Paper Jam In The Fuser Section - Oce PlotWave 750 Operation Manual

Paper jam in the fuser section

CAUTION
During normal use the fuser must be closed. Only open it to remove paper after a paper jam.
Because of hot surfaces, the operator always has to be cautious and wear heat-protective
gloves when removing printing material in the fuser section.
Procedure
1.
Turn off the printer.
2. Wait a few moments to let the fuser cool down.
3. Open the manual feeder to release the printing material.
[90] Manual feed section
NOTE
If you fail to do so, the OPC drum might get damaged when you remove jammed material.
4.
Open the cover on the left-hand side; see the illustration below.
During normal use, the left-hand cover has to be closed. This is necessary to ensure proper
operation.
Chapter 7 - Maintain and troubleshoot the Océ PlotWave 750 system
Paper jam in the fuser section
249