Table of Contents
Advertisement
Proceed as follows:
[544]
4.
[545]
Caution
Fuser rollers may have been switched.
Ensure that the new fuser roller has the same part number as the old one.
5.
Prepare carton for old fuser roller.
[546]
Caution
During operation, the components in the fuser station reach a surface tem-
perature of approximately 230
You could burn yourself if you touch it.
Put on heat protection gloves to continue working.
6.
Put on heat protection gloves again if you have removed them.
[547]
7.
Remove the new fuser roller
with the plastic cover and place
vertically on a surface (the cir-
cular notches at the end must be
on top).
o
C.
Fasten three wing screws uni-
formly to secure the fuser roller
insert (only one turn for each
wing screw).
Remove fuser roller
391
Advertisement
Table of Contents
