Table of Contents
Advertisement
[83]
Printer 1
Printer 2
Setting the page integrity mark (PIM) in twin mode "duplex"
[84]
Position of PIM mark
Printer 2
PIM mark printer 2
[202]
PIM mark printer 1 on the back of the
paper
N1, N2: Vertical position of the PIM
The spacing from the upper margin of the page to the PIM is given in
increments.
The minimum space is 2 increments, i.e. the PIM is positioned after the 2nd hole.
The length of the mark is 2 inches (4 holes).
The maximum value depends on the values set in the menu 'VarioStream' ->
'Configuration' -> 'Paper' -> 'Dimensions' -> 'Paper length'.
[85]
Printer 1
Printer 2
Synchronization - Page integrity marks (PIM) for perforated paper
N1
1
in
/
" increments
2
N1
1
in
/
" increments
2
N2
2 to paper length 4
6 to paper length
Printer 1
PIM mark printer 1
[203]
N2
2 to paper length 4
6 to paper length
1
/
inch
2
165
Advertisement
Table of Contents
