Table of Contents
Advertisement
Clean soft fuser roller
Clean soft fuser roller
Introduction
If toner residue is on the fuser roller, the fuser roller must be cleaned. Especially if
paper has passed through the fuser roller, toner may be stuck on the fuser roller.
Caution: Strictly observe the following safety directives when cleaning the
fuser roller:
Clean the soft fuser rollers only when cooled, otherwise there is a danger
of burning. For this reason, allow the open fuser station to cool down for
at least 30 minutes before cleaning the fuser roller.
The cleaning agent is very flammable. Danger of fire!
Do not allow the cleaning agent to come into contact with the eyes. In the
event of contact with eyes, rinse eyes out with plenty of cold water and
seek medical help.
Do not breath in the cleaning agent vapors. If you experience unpleasant
symptoms after inhaling, immediately go into the fresh air and, if
necessary, call a doctor.
Keep cleaning agent out of the reach of children and store it away from
containers used for food and drink.
Attention: Strictly observe the following safety directives when cleaning the
fuser roller:
Do not use hard objects for cleaning, otherwise there may be damage to the
fuser roller.
Clean the soft fuser roller only with the prescribed cleaning agent (roller
cleaner 6-1508/W1/H).
To clean the soft fuser roller
[140]
Proceed as follows:
1.
Power off the printing system.
2.
Open the front and side door of the fuser station.
270
Chapter 7 Cleaning the printing system
Advertisement
Table of Contents
